Features and Benefits

• Straight fitting in industry standard AN flared 37-degree sealing surface
• Use with any industry-standard PFTE hose
• Can work with kinds of liquids, fuel, oil, water, gas, ect.Especially for E85 ethanol gasoline.
• 6061 aluminum
• Aluminum compression sleeve/ferrule
• Reusable
• Easy to assemble

Installation Procedure:

• Measure and cut your hose, being careful to get a clean square cut on the end. (wrap with tape before cutting to get a clean cut)
• After cut, you can see how the tool did compress a hose a bit, it’s a little bit squished, it’s more of elliptical than a circle.
• You can take any ballpoint pen insert into the end of a hose and just round things out again.
• Slide the sleeve over the end of the hose then carefully separate the steel braid from the inner PTFE liner. This can be done using a screwdriver and some patience.
• Put the Ferrule /olive between the braid and the talon. Push the olive over the inner hose liner until the ends are flush.
• Then make sure that any stray strands of braid are trimmed away.
• Lightly lubricate the threads and nipple insert, push the hose over the nipple until it is fully seated.
• Place the nipple in your bench vise using padded jaws, and use an aluminum wrench to protect the finish, continue screwing the fitting together until it is completely assembled.